ISO-17662 › Historical Revision Information
Welding - Calibration, verification and validation of equipment used for welding, including ancillary activities

ISO-17662 - 1ST EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 17662:2005 specifies requirements for calibration, verification and validation of equipment used for:

  • control of process variables during fabrication;
  • control of the properties of equipment used for welding or welding allied processes,

where the resulting output cannot be readily or economically documented by subsequent monitoring, inspection and testing. This regards process variables influencing the fitness-for-purpose and in particular the safety of the fabricated product.

The subject of ISO 17662:2005 is limited to calibration, verification and validation of equipment after installation, as part of the workshops' schemes for maintenance and/or operation.

ORDER

To find similar documents by classification:

25.160.30 (Welding equipment Including thermal cutting equipment)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 17662:2005

Revision Level

1ST EDITION

Status

Superseded

Publication Date

March 15, 2005

Committee Number

ISO/TC 44/SC 10