ISO-1853 › Historical Revision Information
Conducting and dissipative rubbers, vulcanized or thermoplastic - Measurement of resistivity
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 1853:2011 specifies the requirements for the laboratory testing of the volume resistivity of specially prepared test pieces of vulcanized or thermoplastic rubber compounds rendered conducting or dissipative by the inclusion of carbon black or ionizable materials. The tests are suitable for materials with a resistivity of less than about 108 ohm metres.
Method 1 is the preferred method when test pieces with bonded electrodes are not available.
Method 2 is the preferred method when test pieces are moulded with the inclusion of bonded electrodes.
Method 3 may be used if methods 1 and 2 are not suitable, but it has lower accuracy.
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 1853:1998
Revision Level
2ND EDITION
Status
Superseded
Publication Date
March 1, 1998
Committee Number
ISO/TC 45/SC 2