ISO-18595 › Historical Revision Information
Resistance Welding - Spot Welding of Aluminium & Aluminium Alloys - Weldability, Weldi
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 18595:2007 specifies requirements for resistance spot welding in the fabrication of assemblies of aluminium sheet, extrusions (both work- and age-hardening alloys) and/or cast material comprising two or three thicknesses of metal, where the maximum single (sheet) thickness of components to be welded is within the range 0,6 mm to 6 mm.
ISO 18595:2007 is applicable to the welding of sheets or plates of dissimilar thickness where the thickness ratio is less than or equal to 3:1. It applies to the welding of three thicknesses where the total thickness is less than or equal to 9 mm.
Welding with the following types of machines is within the scope of ISO 18595:2007: pedestal welding machines; gun welders; automatic welding equipment where the components are fed by robots or automatic feeding equipment; multi-welders; robotic welders.
The welding of coated material, e. g. zinc coated or anodised material, is not within the scope of ISO 18595:2007.
To find similar documents by classification:
25.160.10 (Welding processes Including thermal cutting and cladding)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 18595:2007
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Sept. 1, 2007
Committee Number
ISO/TC 44/SC 6