ISO-1872-1 › Historical Revision Information
Plastics - Polyethylene (PE) moulding and extrusion materials - Part 1: Designation system and basis for specifications
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
The types of polyethylene plastics are differentiated from each other by a classification system based on appropriate levels of the designatory properties density and melt flow rate and on information about the intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials. Is applicable to materials ready for normal use in the form of powder, granules or pellets and to materials unmodified or modified by colorants, additives, fillers, etc.
To find similar documents by classification:
83.080.20 (Thermoplastic materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO-1872-1
Revision Level
REPLACED BY ISO-17855-1
Status
Superseded
Publication Date
Oct. 15, 2014
Committee Number
ISO TC 61/SC 9/WG 6