ISO-20457 › Plastics moulded parts - Tolerances and acceptance conditions
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies possible manufacturing tolerances for plastic moulded parts.
This document specifies all integral features with general tolerances with surface profile tolerance within a specified datum system. It allows for additional specifications in case of functional needs and requirements using the ISO-GPS-tools for dimensional and geometrical tolerating.
This document addresses injection moulding, injection compression moulding, transfer moulding, compression moulding and rotational moulding of non-porous moulded parts made from thermoplastics, thermoplastic elastomers and thermosets of thermoplastics. This document is applicable to other plastic processes if agreed to by the contractual parties.
Moulded part surface imperfections such as sink marks, undesired flow structures and roughness, as well as joint lines are not addressed in this document.
This document is not intended to supplant, replace or in any way interfere with requirements for tolerances found in product standards.
To find similar documents by classification:
83.140.01 (Rubber and plastics products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-D4169Standard Practice for Performance Testing of Shipping Containers and Systems
ISO-13485
Medical devices - Quality management systems - Requirements for regulatory purposes
IEC-60529
Degrees of protection provided by enclosures (IP Code)
Document Number
ISO 20457:2018
Revision Level
1ST EDITION
Status
Current
Publication Date
Sept. 1, 2018
Committee Number
ISO/TC 61