ISO-235 › Historical Revision Information
Parallel shank jobber and stub series drills and Morse taper shank drills
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This secon edition, which superseded ISO 235-1:1975, incorporates draft Amendment 1. ISO 235 specifies in dimensions of the above mentioned drills. It comprises, for each type of these drills, three tables giving respectively the dimensions in millimetres, the dimensions in inches, the corrsponding length, in millimetres and in inches, set out as functions of diameter steps.
To find similar documents by classification:
25.100.30 (Drills, countersinks, reamers)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 235:1980
Revision Level
2ND EDITION
Status
Superseded
Publication Date
Nov. 1, 1980
Committee Number
ISO TC 29/SC 2