ISO-23529 › Historical Revision Information
Rubber - General procedures for preparing and conditioning test pieces for physical test methods

ISO-23529 - 1ST EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 23529:2010 specifies general procedures for the preparation, measurement, marking, storage, and conditioning of rubber test pieces for use in physical tests specified in other International Standards, and the preferred conditions to be used during the tests. Special conditions, applicable to a particular test or material or simulating a particular climatic environment, are not included, nor are special requirements for testing whole products.

ISO 23529:2010 also specifies the requirements for the time interval to be observed between forming and testing of rubber test pieces and products. Such requirements are necessary to obtain reproducible test results and to minimize disagreements between customer and supplier.

ORDER

To find similar documents by classification:

83.060 (Rubber Raw rubber, see 83.040.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 23529:2004

Revision Level

1ST EDITION

Status

Superseded

Publication Date

Sept. 1, 2004

Committee Number

ISO/TC 45/SC 2