ISO-241 › Historical Revision Information
Shanks for Turning & Planing Tools - Shapes & Dimensions Ofthe Section

ISO-241 - 1ST EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


Cancels and replaces the first edition (1975). Specifies the types and dimensions of the section of shanks for turning and planing tools of high speed steel and with brazed hardmetal tips. Specifies three types: round section; square section; rectangular sections with ratios of height to width of approximately 1,25; 1,6 and 2.

ORDER

To find similar documents by classification:

25.100.10 (Turning tools)

25.100.25 (Tools for planning and broaching machines)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 241:1975

Revision Level

1ST EDITION

Status

Superseded

Publication Date

Feb. 1, 1975

Committee Number

ISO TC 29/SC 9