ISO-286-1 › Historical Revision Information
ISO system of limits and fits - Part 1 : Bases of tolerances, deviations and fits

ISO-286-1 - 1ST EDITION - SUPERSEDED -- See the following: EN-20286-1
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 286-1:2010 establishes the ISO code system for tolerances to be used for linear sizes of features of the following types: a) cylinder; b) two parallel opposite surfaces.

ISO 286-1:2010 defines the basic concepts and the related terminology for this code system. It provides a standardized selection of tolerance classes for general purposes from amongst the numerous possibilities.

Additionally, it defines the basic terminology for fits between two features of size without constraints of orientation and location and explains the principles of “basic hole” and “basic shaft”.

ORDER

To find similar documents by classification:

17.040.10 (Limits and fits)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 286-1:1988

Revision Level

1ST EDITION

Status

Superseded

Publication Date

Sept. 15, 1988

Committee Number

ISO/TC 213