ISO-2974 › Historical Revision Information
Diesel engines - 60 Degrees female cones for high-pressure fuel injection components
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 2974:2013 specifies the dimensional requirements of end-connections for high-pressure fuel injection equipment components used on diesel (compression-ignition) engines.
It is applicable to externally threaded 60° female cones and intended for use with high-pressure fuel injection pipe assemblies with tube outside diameters of
- up to and including 12 mm for integral female cones, and
- up to and including 9 mm for fabricated female cones.
Details of the pipe connection ends referenced in this document are shown in ISO 13296.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 2974:1989
Revision Level
1989 EDITION
Status
Superseded
Publication Date
Jan. 1, 1989
Committee Number
ISO/TC 22/SC 7