ISO-2974 › Historical Revision Information
Diesel engines - 60 Deg female cones for high-pressure fuel injection components
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 2974:2018 specifies the dimensional requirements of end-connections for high-pressure fuel injection equipment components, used on diesel (compression-ignition) engines.
ISO 2974:2018 is applicable to externally threaded 60° female cones (see Figures 1, 2, 5, and 6) and intended for use with high-pressure fuel injection pipe assemblies with tube outside diameters of:
- up to and including 12 mm for integral female cones (see Table 1); and
- up to and including 9 mm for fabricated female cones (see Table 2).
Details of the pipe connection ends referenced in this document are shown in ISO 13296.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 2974:2018
Revision Level
9TH EDITION
Status
Current
Publication Date
March 1, 2018
Committee Number
ISO/TC 22/SC 34