ISO-3294 › Historical Revision Information
Parallel shank countersinks for angles 60, 90 and 120 degrees inclusive
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Specifies only metric dimensions of these countersinks. Metric dimensions being regarded as the only recommended dimensions in the future, for these countersinks with cutting diameters in the range 8 to 25 mm. The dimensions given apply only to tools made from high speed steel or a suitable carbon steel. These countersinks will be usually right-hand cutting.
To find similar documents by classification:
25.100.30 (Drills, countersinks, reamers)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 3294:1975
Revision Level
1ST EDITION
Status
Superseded
Publication Date
July 15, 1975
Committee Number
ISO TC 29/SC 2