ISO-3302-1 › Historical Revision Information
Rubber - Tolerances for products - Part 1: Dimensional tolerances
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 3302 specifies classes of dimensional tolerances, and their values, for moulded, extruded and calendered solid rubber products. The relevant test methods necessary for the establishment of compliance with this International Standard are also specified.
The tolerances are primarily intended for use with vul-canized rubber but may also be
To find similar documents by classification:
83.140.01 (Rubber and plastics products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO-3302-1
Revision Level
FOR 1ST EDITION AMENDMENT 1 SEE
Status
Superseded
Publication Date
June 1, 2001
Committee Number
ISO TC 45/SC 4