ISO-3302-2 › Historical Revision Information
Part 2: Geometrical Tolerances, Rubber - Tolerances for Products
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 3302-2:2008 specifies the following geometrical tolerances for moulded and extruded solid rubber products, including those with metal inserts:
- flatness tolerance;
- parallelism tolerance;
- perpendicularity tolerance;
- coaxiality tolerance;
- positional tolerance.
The tolerances are primarily intended for use with vulcanized rubber but may also be suitable for products made of thermoplastic rubbers.
To find similar documents by classification:
83.140.01 (Rubber and plastics products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 3302-2:1998
Revision Level
1ST EDITION
Status
Superseded
Publication Date
March 15, 1998
Committee Number
ISO/TC 45/SC 4