ISO-4753 › Historical Revision Information
Fasteners - Ends of parts with external ISO metric thread
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 4753:2011 specifies the form and dimensions of ends of parts with external ISO metric screw thread (e.g. bolt, screw and stud ends) recommended for use. They apply to standardized or non-standardized threaded parts.
For each end type, a symbol is specified and it is intended that these symbols be used when specifying one of the ends for threaded fasteners.
To find similar documents by classification:
21.060.01 (Fasteners in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 4753:1983
Revision Level
1ST EDITION
Status
Superseded
Publication Date
May 1, 1983
Committee Number
ISO/TC 2/SC 7