ISO-4759-3 › Historical Revision Information
Tolerances for fasteners -- Part 3: Plain washers for bolts, screws and nuts -- Product grades A and C
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 4759 establishes a selection of tolerances for use in the preparation of ISO product standards for punched plain washers of product grades A and C, for use with bolts, screws and nuts of nominal thread diameters of from 1 mm to 150 mm inclusive.
It is recommended that these tolerances also be used for non-standard washers.
Annex A (informative) presents tolerances taken from ISO 286-1 and ISO 286-2.
To find similar documents by classification:
21.060.30 (Washers, locking elements)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 4759-3:2000
Revision Level
3RD EDITION
Status
Superseded
Publication Date
May 1, 2000
Committee Number
ISO TC 2/WG 6