ISO-51401 › Historical Revision Information
Practice for use of a dichromate dosimetry system
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
ISO/ASTM 51401:2013 covers the preparation, testing, and procedure for using the acidic aqueous silver dichromate dosimetry system to measure absorbed dose to water when exposed to ionizing radiation. The system consists of a dosimeter and appropriate analytical instrumentation. For simplicity, the system will be referred to as the dichromate system. The dichromate dosimeter is classified as a type I dosimeter on the basis of the effect of influence quantities. The dichromate system can be used as either a reference standard dosimetry system or a routine dosimetry system.
ISO/ASTM 51401:2013 is one of a set of standards that provides recommendations for properly implementing dosimetry in radiation processing, and describes a means of achieving compliance with the requirements of ISO/ASTM Practice 52628 for the dichromate dosimetry system. It is intended to be read in conjunction with ISO/ASTM Practice 52628.
ISO/ASTM 51401:2013 describes the spectrophotometric analysis procedures for the dichromate system. It applies only to gamma radiation, X-radiation/bremsstrahlung, and high energy electrons.
To find similar documents by classification:
17.240 (Radiation measurements Including dosimetry Radiation protection, see 13.280)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO/ASTM 51401:2002
Revision Level
1ST EDITION
Status
Superseded
Publication Date
March 15, 2002
Committee Number
ISO/TC 85