ISO-630-3 › Structural steels - Part 3: Technical delivery conditions for fine-grain structural steels
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies requirements for flat and long products of hot-rolled weldable fine-grain structural steels in the as-rolled (for SG grades only), normalized/normalized rolled and thermomechanical processed delivery conditions. It applies to steel plates rolled on a reversing mill, wide flats, hot-rolled sections and bars, which are intended for use in heavily loaded parts of welded or bolted structures.
This document coversÂ 13 grades and 6 qualities. Grades S275, S355, S390, S420, S460 and S500 are covered in AnnexÂ A. Grades SG245, SG290, SG325, SG345, SG365, SG415 and SG460 are covered in AnnexÂ B. Not all grades are available in all qualities, and some qualities have Charpy V-notch requirements.
The steels specified in this document are applicable to hot-rolled plates, wide flats, sections and bars with a minimum nominal thickness of 3Â mm and a maximum nominal thickness of 250Â mm for grades S275N, S355N, S390N, S420N and S460N, a maximum nominal thickness of 150Â mm for grades S275M, S355M, S390M, S420M, S460M, and S500M, a maximum nominal thickness of 200Â mm for grades SG245, SG325 and SG415, a maximum nominal thickness of 100Â mm for grades SG345, SG365 and SG460, and a maximum nominal thickness of 40Â mm for grade SG290.
This document does not include the following structural steels, some of which are covered by other International Standards:
â..Â Â Â Sheet and strip â.. refer to ISO TCÂ 17/SCÂ 12, Continuous mill flat rolled products;
â..Â Â Â Tubular products â.. refer to ISO TCÂ 5/SCÂ 1, Steel tubes.
NOTEÂ 1Â Â Â Lists of standards covered by ISO/TCÂ 17/SCÂ 12 and ISO/TCÂ 5/SCÂ 1 are available on the ISO website.
NOTEÂ 2Â Â Â In all parts of ISOÂ 630, the term of "thickness" is considered as "nominal thickness", unless otherwise stated.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
April 1, 2021
ISO/TC 17/SC 3