ISO-6361-3 › Historical Revision Information
Wrought aluminium and aluminium alloy sheets, strips and plates - Part 3 : Strips - Tolerances on shape and dimensions
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 6361-3:2011 specifies the tolerances on shape and dimensions for wrought aluminium and aluminium alloy strip by cold-rolling for general engineering applications.
It applies to products with a thickness over 0,15 mm up to and including 16 mm.
It does not apply to semi-finished rolled products in coiled form to be subjected to further rolling (reroll stock) or to special products such as those that are corrugated or embossed.
Technical conditions for inspection and delivery of products covered by ISO 6361-3:2011 are specified in ISO 6361-1.
To find similar documents by classification:
77.150.10 (Aluminium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 6361-3:1985
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Oct. 15, 1985
Committee Number
ISO/TC 79/SC 6