ISO-6363-5 › Historical Revision Information
Wrought aluminium and aluminium alloy cold-drawn rods/bars and tubes - Part 5: Drawn square and hexagonal bars - Tolerances on form and dimensions
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 6363-5:2012 specifies the tolerances on form and dimensions of wrought aluminium and aluminium alloy drawn square and hexagonal bars and wires with widths across flats up to and including 100 mm.
To find similar documents by classification:
77.150.10 (Aluminium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 6363-5:1992
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Nov. 15, 1992
Committee Number
ISO/TC 79/SC 6