ISO-6363-5 › Historical Revision Information
Wrought aluminium and aluminium alloys - Cold-drawn rods/bars, tubes and wires - Part 5: Drawn square and hexagonal bars and wires - Tolerances on form and dimensions
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 6363-5:2012 specifies the tolerances on form and dimensions of wrought aluminium and aluminium alloy drawn square and hexagonal bars and wires with widths across flats up to and including 100 mm.
To find similar documents by classification:
77.150.10 (Aluminium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 6363-5:2012
Revision Level
2ND EDITION
Status
Superseded
Publication Date
July 15, 2012
Committee Number
ISO/TC 79/SC 6