ISO-6520-2 › Historical Revision Information
Welding and allied processes - Classification of geometric imperfections in metallic materials - Part 2: Welding with pressure

ISO-6520-2 - 1ST EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 6520-2:2013 collects and classifies the possible imperfections in welds made with pressure. A uniform designation is specified. Only the type, shape, and dimensions of the different imperfections caused by welding with pressure are included. Metallurgical deviations are not taken into account. Imperfections produced other than by the welding operation, e.g. additional stresses, loads or environmental factors, are not covered by ISO 6520-2:2013.

Information concerning the consequences of the imperfections mentioned and the use of particular structures is not given, because this depends on the specific requirements of the joint.

ORDER

To find similar documents by classification:

25.160.40 (Welded joints and welds Including welding position and mechanical and non-destructive testing of welded joints)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 6520-2:2001

Revision Level

1ST EDITION

Status

Superseded

Publication Date

Dec. 15, 2001

Committee Number

ISO/TC 44/SC 7