ISO-7206-2 › Historical Revision Information
Implants for surgery - Partial and total hip joint prostheses - Part 2: Articulating surfaces made of metallic, ceramic and plastics materials
ISO-7206-2
-
3RD EDITION
-
CURRENT
-- See the following:
ISO-7206-2-AM1
Show Complete Document History
Show Complete Document History
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 7206-2:2011 specifies requirements for the articulating surfaces of those types of total and partial hip joint prostheses that provide a joint replacement of ball and socket configuration, as follows:
- sphericity and surface finish requirements for metallic and ceramic femoral prostheses for partial hip joint replacement that are in accordance with classification a) of ISO 7206-1;
- sphericity and surface finish requirements for bipolar heads with plastics inner surfaces which articulate on femoral components that are in accordance with classification a) of ISO 7206-1 and with metallic or ceramic outer surfaces which articulate on the biological acetabulum;
- sphericity and surface finish requirements and dimensional tolerances for plastics acetabular components that are in accordance with classification b) of ISO 7206-1;
- sphericity and surface finish requirements and dimensional tolerances for metallic or ceramic femoral components of total hip joint prostheses that are in accordance with classification c) of ISO 7206-1, designed to articulate on plastics acetabular components.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 7206-2:2011
Revision Level
3RD EDITION
Status
Current
Publication Date
April 1, 2011
Committee Number
ISO/TC 150/SC 4