ISO-8062-3 › Historical Revision Information
Corrigendum
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 8062-3:2007 specifies general dimensional and geometrical tolerances, as well as machining allowance grades, for castings as delivered to the purchaser in accordance with ISO 8062-2. It is applicable for the tolerancing of dimensions and geometry, and required machining allowance of castings in all cast metals and their alloys produced by various casting manufacturing processes.
ISO 8062-3:2007 applies to both general dimensional and general geometrical tolerances, unless otherwise specified.
The dimensional tolerances covered by ISO 8062-3:2007 are tolerances for linear dimensions.
The geometrical tolerances covered by ISO 8062-3:2007 are:
- tolerances for straightness,
- flatness,
- roundness,
- parallelism,
- perpendicularity,
- symmetry, and
- coaxiality.
ISO 8062-3:2007 can be used for the selection of tolerance values for individual indications.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 8062-3/Cor1:2009
Revision Level
1ST EDITION CORRIGENDUM 1
Status
Superseded
Publication Date
Jan. 15, 2009
Committee Number
ISO/TC 213