ISO-8405 › Historical Revision Information
Tools for moulding - Ejector sleeves with cylindrical head - Basic series for general purposes
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 8405:2013 specifies the dimensions and tolerances, in millimetres, of ejector sleeves with cylindrical head which are used in compression and injection moulds and in die casting dies. It also gives material guidelines and hardness requirements, and specifies the designation of ejector sleeves with cylindrical head.
To find similar documents by classification:
25.120.30 (Moulding equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 8405:2013
Revision Level
3RD EDITION
Status
Superseded
Publication Date
Sept. 15, 2013
Committee Number
ISO/TC 29/SC 8