ISO-871 › Historical Revision Information
Plastics - Determination of Ignition Temperature Using a Hot-Air Furnace
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 871:2006 specifies a laboratory method for determining the flash-ignition temperature and spontaneous-ignition temperature of plastics using a hot-air furnace. It is one of a number of methods in use for evaluating the reaction of plastics to the effects of ignition sources.
The method described does not give a direct measure of the combustibility or rate of burning of a material or any definition of the safe upper limit of temperature for the plastics in use, and is not intended to be used alone to describe or appraise the fire hazard or fire risk of materials, products or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire hazard or fire risk assessment which takes into account all of the factors pertinent to an assessment of the fire hazard of a particular end use.
Tests made under conditions of this method can be of considerable value in comparing the relative ignition characteristics of different materials. Values obtained represent the lowest ambient air temperature that will cause ignition of the material under the conditions of this test. Test values are expected to rank materials according to ignition susceptibility under actual use conditions.
To find similar documents by classification:
13.220.40 (Ignitability and burning behaviour of materials and products)
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 871:2006
Revision Level
3RD EDITION
Status
Superseded
Publication Date
Nov. 15, 2006
Committee Number
ISO/TC 61/SC 4