ISO-9012 › Historical Revision Information
Gas Welding Equipment - Air-Aspirated Hand Blowpipes - Specifications & Tests
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 9012:2008 specifies requirements and test methods for air-aspirated hand blowpipes.
ISO 9012:2008 applies to blowpipes for brazing, soldering, heating, fusion and other allied thermal processes, which use a fuel gas and aspirated air (injector-type blowpipes), and are intended for manual use.
ISO 9012:2008 is applicable to: air-aspirated hand blowpipes which are fed with a fuel gas in the gaseous phase, at a controlled pressure by a regulator, through a gas supply hose; air-aspirated hand blowpipes which are fed with a liquefied fuel gas in the gaseous phase at the container pressure, through a gas supply hose; so-called liquid-phase blowpipes which are fed with a fuel gas in the liquid phase, and where thermal evaporation takes place within the blowpipe.
To find similar documents by classification:
25.160.30 (Welding equipment Including thermal cutting equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 9012:1988
Revision Level
1ST EDITION
Status
Superseded
Publication Date
April 1, 1988
Committee Number
ISO/TC 44/SC 8