Document Center is acquired by Nimonik

1.1 Scope of FprCEN/TS 19101 (1) This document applies to the design of buildings, bridges and other civil engineering structures in fibre-polymer composite materials, including permanent and temporary structures. It complies with the principles and requirements for the safety, serviceability and durability of structures, the basis of their design and verification that are given in EN 1990. NOTE In this document, fibre-polymer composite materials are referred to as composite materials or as composites. (2) This document is only concerned with the requirements for resistance, serviceability, durability and fire resistance of composite structures. NOTE 1 Specific requirements concerning seismic design are not considered. NOTE 2 Other requirements, e.g. concerning thermal or acoustic insulation, are not considered. (3) This document gives a general basis for the design of composite structures composed of (i) composite members, or (ii) combinations of composite members and members of other materials (hybrid-composite structures), and (iii) the joints between these members. (4) This document applies to composite structures in which the values of material temperature in members, joints and components in service conditions are (i) higher than -40 °C and (ii) lower than - 20 °C, where is the glass transition temperature of composite, core and adhesive materials, defined according to 5.1(1). (5) This document applies to: (i) composite members, i.e. profiles and sandwich panels, and (ii) bolted, bonded and hybrid joints and their connections. NOTE 1 Profiles and sandwich panels can be applied in structural systems such as beams, columns, frames, trusses, slabs, plates and shells. NOTE 2 Sandwich panels include homogenous core and web-core panels. In web-core panels, the cells between webs can be filled (e.g. with foam) or remain empty (e.g. panels from pultruded profiles). NOTE 3 This document does not apply to sandwich panels made of metallic face sheets...