SS-EN-10162 › Cold rolled steel sections - Technical delivery conditions - Dimensional and cross-sectional tolerances
SS-EN-10162
-
EDITION 1
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies dimensional and cross-sectional tolerances for cold rolled steel sections produced on roll-forming machines. It applies to cold-rolled sections for general use (standard sections) produced from steels conforming to EN 10025, EN 10142 and EN 10147 and in the form of rectangular L, U, C, Z and Omega cross sections as well as split tubes (see Figures 1 to 6). It also applies to cold rolled sections for special applications (special sections) produced from steels listed in clause 5 with other radii, tolerances and shapes. NOTE Examples of special sections are sections for steel-framed buildings, door frames and sections for rolling stock, automobiles and bridge engineering (see Figures 7 and 8). This European Standard does not apply to drawn, pressed or folded cold formed sections, cold rolled steel piling or sections manufactured on the basis of special standards.
To find similar documents by classification:
77.140.70 (Steel profiles Including sections)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 10162
Revision Level
EDITION 1
Status
Current
Publication Date
May 9, 2003
Language(s)
English
Page Count
22
International Equivalent
EN 10162:2003(IDT)