SS-EN-1112 › Historical Revision Information
Sanitary tapware - Shower outlets for sanitary tapware for water supply systems type 1 and type 2 - General technical specification
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies: - the dimensional, leaktightness, mechanical, hydraulic and acoustic characteristics with which shower outlets shall comply; - the procedures for testing these characteristics. This European Standard applies to shower heads and hand showers of any material used for ablutionary purposes and intended for equipping and supplementing sanitary tapware for baths and showers. This European Standard applies to shower heads and hand showers connected downstream of the obturator of the tapware. Integral and remote spray attachments incorporated in tapware (e.g. sink and wash basin mixing valves) are not covered by this standard. Details of pressures and temperatures are given in Table 1.
To find similar documents by classification:
23.040.70 (Hoses and hose assemblies)
91.140.70 (Sanitary installations Including bidets, kitchen sinks, baths, waste chutes, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1112:2008
Revision Level
2008 EDITION
Status
Current
Publication Date
March 10, 2008
Language(s)
English
Page Count
32
International Equivalent
EN 1112:2008(IDT)