SS-EN-1113 › Historical Revision Information
Sanitary tapware - Shower hoses for sanitary tapware for water supply systems of type 1 and type 2 - General technical specification
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies: - the dimensional, leaktightness, mechanical and hydraulic characteristics with which shower hoses shall comply; - the procedures for testing these characteristics. This European Standard applies to shower hoses of any material used for ablutionary purposes and intended for equipping and supplementing sanitary tapware for baths and showers. This European Standard applies to shower hoses connected downstream of the obturator of the tapware. Hoses which are an integral part of sanitary tapware (sink and wash basin mixing valves) or hoses intended to connect sanitary tapware to the water supplies are not covered by this European Standard.
To find similar documents by classification:
23.040.70 (Hoses and hose assemblies)
91.140.70 (Sanitary installations Including bidets, kitchen sinks, baths, waste chutes, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1113:2008+A1:2011
Revision Level
2008/A1 EDITION
Status
Superseded
Publication Date
March 10, 2011
Language(s)
English
Page Count
32
International Equivalent
EN 1113:2008+A1:2011(IDT)