SS-EN-12168 › Historical Revision Information
Copper and copper alloys - Hollow rod for free machining purposes
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies the composition, property requirements and dimensional tolerances for copper alloy hollow rod, finally produced by drawing or extruding, specifically intended for free machining purposes. NOTE Hollow products having an outside diameter greater than 80 mm and/or a wall thickness less than 2 mm are specified in EN 12449. The sampling procedures, the methods of test for verification of conformity to the requirements of this European Standard, are also specified.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 12168:2011
Revision Level
2011 EDITION
Status
Superseded
Publication Date
June 23, 2011
Language(s)
English
Page Count
40
International Equivalent
EN 12168:2011(IDT)