SS-EN-1301-3 › Historical Revision Information
Aluminium and aluminium alloys - Drawn wire - Part 3: Tolerances on dimensions
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Defines tolerances on dimensions of aluminium and aluminium alloy drawn wire for general engineering applications including rivet manufacture (not including aeronautical rivets) which covers diameters, thicknesses or width across flats up to and including 20 mm. Applicable to drawn wires, excepting welding and electrical applications.
To find similar documents by classification:
77.150.10 (Aluminium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1301-3
Revision Level
EDITION 1
Status
Superseded
Publication Date
Oct. 9, 1998
Language(s)
English
Page Count
4
International Equivalent
EN 1301-3:1997 IDT