SS-EN-1337-3 › Structural bearings - Part 3: Elastomeric bearings
SS-EN-1337-3
-
2005 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of EN 1337 applies to elastomeric bearings with or without complementary bearing devices to extend their field of use such as flat sliding elements covered by EN 1337-2 or sliding surface described in 4.4.4, as used in bridge structures or any other structure with comparable support conditions. This part of EN 1337 applies to elastomeric bearings with dimensions in plan up to (1200 x 1200) mm and does not cover elastomeric bearings made with other elastomers materials than those specified in 4.4.1. It applies to laminated bearings types A, B, C, laminated sliding bearings types E and D, plain pad and strip bearings type F. This part deals with bearings for use in operating temperatures ranging from 25 °C to + 50 °C and for short periods up to + 70 °C. It is recognised that the air temperature in some regions of Northern Europe is lower than 25 °C. In this case of very low operating temperature (down to 40 °C), it is essential that bearing characteristics comply also with the shear modulus at very low temperature (see 4.3.1.3. and annex F)
To find similar documents by classification:
Construction products
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1337-3:2005
Revision Level
2005 EDITION
Status
Current
Publication Date
April 8, 2005
Language(s)
English
Page Count
95
International Equivalent
EN 1337-3:2005(IDT)