SS-EN-13914-1 › Historical Revision Information
Design, preparation and application of external rendering and internal plastering - Part 1: External rendering
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies requirements and recommendations for the design, preparation and application of cement, lime or other mineral binders, and/or combinations thereof, masonry cement and polymer modified binder based external renderings, on all common types of backgrounds, to both vertical walls and horizontal soffits. It includes rendering on both new and old backgrounds and the maintenance and repair of existing work. Renders with organic materials as the principal binder are not included in the scope of this document. This document gives guidance on the use of established site, factory and semi-finished factory made renders. NOTE 1 Because of the many and varied materials and practices in Europe it is not possible for certain aspects of the document to enter into sufficient detail to be fully usable to practitioners in each country. Such recommendations required to complement, but not alter any basic European recommendation are given in documentation prepared by each country. Aspects of this document which may need to be complemented are indicated where they occur by a footnote referencing this paragraph. Due to the wide range of climatic conditions in Europe, it is not possible to recommend precise drying times for backgrounds and render coats. Any times given are for guidance only. This document does not cover the following: a) the use and application of special renders for liquid retaining structures, e.g. coatings, and for backgrounds to cladding systems; b) the structural repair of concrete; c) the installation of proprietary external thermal insulation composite systems (ETICS); d) the specification and use of sealants used to seal joints for use with rendering; e) the use of gypsum based renders used externally, but their use may be permitted in some countries;
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
91.100.15 (Mineral materials and products Including earth, sands, clay, slates, stones, etc.)
91.100.30 (Concrete and concrete products Including admixtures)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 13914-1:2005
Revision Level
2005 EDITION
Status
Superseded
Publication Date
April 1, 2005
Language(s)
English
Page Count
64
International Equivalent
EN 13914-1:2005(IDT)