SS-EN-1858 › Historical Revision Information
Chimneys - Components - Concrete flue blocks
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies the materials, dimensional and performance requirements for concrete flue blocks as defined in clause 3 for use in system chimneys. The flue blocks may be of single wall or multi wall construction. The standard does not apply to blocks with back ventilation. The standard specifies a type of block to dimensionally co-ordinate with masonry unit coursing height, referred to as a type B (Bonding block). This European standard also applies to storey-height and reinforced flue blocks. NOTE 1 Classes in this standard are not derived from conditions referred to in article 3.2 of Directive 89/106/EC, and should only be considered as technical classes in the sense of Commission Guidance Paper E Levels and classes in the Construction Products Directive. NOTE 2 Any reference to the term flue liners implies both flue liners and their fittings, except where otherwise indicated.
To find similar documents by classification:
91.060.40 (Chimneys, shafts, ducts Including flues and flue pipes)
91.100.30 (Concrete and concrete products Including admixtures)
Construction products
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1858:2004
Revision Level
2004 EDITION
Status
Superseded
Publication Date
Jan. 9, 2004
Language(s)
English
Page Count
54
International Equivalent
EN 1858:2003(IDT)