SS-EN-ISO-10447 › Historical Revision Information
Resistance welding - Peel and chisel testing of resistance spot and projection welds (ISO 10447:2006)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies the procedure and recommended tooling to be used for testing resistance spot and projection welds by means of peel and chisel tests. It applies to welds made in two or more sheets in the thickness range of 0,5 mm to 3,0 mm. The aim of these tests is to determine: -- weld size and failure type when the tests are used as destructive tests, and -- verification of welds when the tests are used as non-destructive tests. NOTE In the previous edition of this International Standard, seam welds were included. The preferred method of peel testing seam welds (mechanized peel testing) is now covered in ISO 14270.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 10447:2007
Revision Level
2007 EDITION
Status
Superseded
Publication Date
June 28, 2007
Language(s)
English
Page Count
12
International Equivalent
EN ISO 10447:2007(IDT); ISO 10447:2006(IDT)