SS-EN-ISO-10447 › Historical Revision Information
Resistance welding - Testing of welds - Peel and chisel testing of resistance spot and projection welds (ISO 10447:2015)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies the procedures and recommended tooling to be used for peel and chisel testing of resistance spot and projection welds. This International Standard applies to welds made in two or more sheets in the thickness range of 0,5 mm to 3,0 mm.The aim of these tests is to determine weld size and failure type when welds are destructively tested, and verification of welds by non-destructive chisel tests.NOTE The preferred method of peel testing seam welds (mechanized peel testing) is covered in ISO 14270.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 10447:2015
Revision Level
2015 EDITION
Status
Superseded
Publication Date
Feb. 24, 2015
Language(s)
English
Page Count
24
International Equivalent
EN ISO 10447:2015(IDT); ISO 10447:2015(IDT)