SS-EN-ISO-11403-1 › Historical Revision Information
Plastics - Acquisition and presentation of comparable multipoint data - Part 1: Mechanical properties (ISO 11403-1:2014)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 11403 specifies test procedures for the acquisition and presentation of multipoint data on the following mechanical properties of plastics: dynamic modulus; tensile properties at constant test speed; ultimate stress and strain; tensile stress-strain curves; tensile creep; Charpy impact strength; puncture impact behaviour.The test methods and test conditions apply predominantly to those plastics that can be injection- or compression-moulded or prepared as sheets of specified thickness from which specimens of the appropriate size can be machined.
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 11403-1:2014
Revision Level
2014 EDITION
Status
Superseded
Publication Date
June 23, 2014
Language(s)
English
Page Count
28
International Equivalent
EN ISO 11403-1:2014(IDT); ISO 11403-1:2014(IDT)