SS-EN-ISO-12215-3 › Historical Revision Information
Small craft - Hull construction and scantlings - Part 3: Materials: Steel, aluminium alloys, wood, other materials (ISO 12215-3:2002)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 12215 specifies requirements for materials intended for use in the construction of the hull, superstructure and appendages, in particular: - weldable normal and higher strength hot-rolled steel plates, wide flats, sections and bars; - austenitic stainless steels, fabricated in the form of plates or profiles; - wrought aluminium alloys fabricated as plates, sections and extruded profiles; - wood in the form of solid timber, plywood or veneer; - other suitable materials. NOTE 1 Other materials may be used in the construction of small craft if adequate suitability and durability for the intended purpose can be demonstrated. This part of ISO 12215 applies to small craft with a length hull (LH) according to ISO 8666 of up to 24 m. NOTE 2 The underlying reason for preparing this part of ISO 12215 is that the choice of materials for the construction of a small craft has a significant influence on short-term and long-term durability under the expected loads and environmental conditions.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 12215-3
Revision Level
EDITION 1
Status
Superseded
Publication Date
May 24, 2002
Language(s)
English
Page Count
15