SS-EN-ISO-13849-2 › Historical Revision Information
Safety of machinery - Safety-related parts of control systems - Part 2: Validation (ISO 13849-2:2003)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies the procedures and conditions to be followed for the validation by analysis and testing of: -- the safety functions provided, and -- the category achieved of the safety-related parts of the control system in compliance with EN 954-1 (ISO 13849-1), using the design rationale provided by the designer. This European Standard does not give complete validation requirements for programmable electronic systems and therefore can require the use of other standards. NOTE CEN/TC 114/WG 6 proposes to deal in more detail with the validation of programmable electronic systems in the elaboration of the revision to EN 954-1 (ISO 13849-1). An application standard for machinery (draft IEC 62061), based on IEC 61508, is under preparation. Requirements for programmable electronic systems, including embedded software, are given in IEC 61508.
To find similar documents by classification:
13.110 (Safety of machinery This group includes standards for general use)
Machinery. Revised Machinery Directive
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 13849-2:2008
Revision Level
2008 EDITION
Status
Superseded
Publication Date
June 23, 2008
Language(s)
English
Page Count
68
International Equivalent
EN ISO 13849-2:2008(IDT); ISO 13849-2:2003(IDT)