SS-EN-ISO-6721-2 › Historical Revision Information
Plastics - Determination of dynamic mechanical properties - Part 2: Torsion-pendulum method (ISO 6721-2:2008)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 6721 specifies two methods (A and B) for determining the linear dynamic mechanical properties of plastics, i.e. the storage and loss components of the torsional modulus, as a function of temperature, for small deformations within the frequency range from 0,1 Hz to 10 Hz. The temperature dependence of these properties, measured over a sufficiently broad range of temperatures (for example from 50 °C to 150 °C for the majority of commercially available plastics), gives information on the transition regions (for example the glass transition and the melting transition) of the polymer. It also provides information concerning the onset of plastic flow. The two methods described are not applicable to non-symmetrical laminates (see ISO 6721-3, Plastics Determination of dynamic mechanical properties Part 3: Flexural vibration Resonance-curve method). The methods are not suitable for testing rubbers, for which the user is referred to ISO 4664-2, Rubber, vulcanized or thermoplastic Determination of dynamic properties Part 2: Torsion pendulum methods at low frequencies.
To find similar documents by classification:
01.040.83 (Rubber and plastics industries (Vocabularies))
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 6721-2:2008
Revision Level
2008 EDITION
Status
Superseded
Publication Date
June 17, 2008
Language(s)
English
Page Count
28
International Equivalent
EN ISO 6721-2:2008(IDT); ISO 6721-2:2008(IDT)