SS-EN-ISO-7233 › Historical Revision Information
Rubber and plastics hoses and hose assemblies - Determination of resistance to vacuum (ISO 7233:2016)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 7233:2016 specifies three methods for determining the resistance to vacuum of hoses and hose assemblies manufactured from plastic or rubber. Applicable dimensions of hoses for each method are as follows: - method A for hoses of nominal bore up to and including 80 mm; - method B for hoses of nominal bore greater than 80 mm; - method C for hoses of all dimensions. Methods A and B can also be used to check the adhesion of the lining to the reinforcement (delamination) in a length of hard-wall hose or hose assembly.
To find similar documents by classification:
23.040.70 (Hoses and hose assemblies)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 7233:2017
Revision Level
2017 EDITION
Status
Superseded
Publication Date
Feb. 6, 2017
Language(s)
English
Page Count
20
International Equivalent
EN ISO 7233:2016(IDT); ISO 7233:2016(IDT)