SS-EN-ISO-8130-1 › Coating powders - Part 1: Determination of particle size distribution by sieving (ISO 8130-1:2019)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies a method for the determination of the particle size distribution of coating powders by sieve analysis. Particle size distributions with a maximum of less than 100 µm is determined by laser diffraction, ISO 8130-13. This method is used especially for determining the oversize material or for the presence of contamination and can be used as a quality control procedure ("go"/"no go" test) by checking the amount retained on a single sieve. The following particle sizes are typical for coating powders, however the particle size can deviate depending on the application: thin-film technology: 1 µm to 63 µm; electrostatic coating: 10 µm to 200 µm; fluidizing-bed method: 100 µm and above. NOTE Sieves with a mesh size smaller than 32 µm are not practical and are likely to become blind during use.
To find similar documents by classification:
87.040 (Paints and varnishes Including coating powders, paint coatings and protective paint systems)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 8130-1:2019
Revision Level
2019 EDITION
Status
Current
Publication Date
May 14, 2019
Language(s)
English
Page Count
24
International Equivalent
EN ISO 8130-1:2019(IDT); ISO 8130-1:2019(IDT)