SS-EN-ISO-8222 › Historical Revision Information
Petroleum measurement systems - Calibration - Temperature corrections for use when calibrating volumetric proving tanks (ISO 8222:2002)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies multiplication factors for the correction of the volume of water transferred from a primary measure to a tank for changes arising from temperature differences during the determination of the capacity of the tank at reference temperature. NOTE This International Standard does not set out a calibration procedure nor consider the uncertainties in temperature measurement, for which reference should be made to other standards. Equations are given in annex A for the determination of the density of air-free and air-saturated, pure water in the temperature range 1,0 oC to 40 oC for temperatures expressed in terms of the ITS-90 International Temperature Scale. A calculation routine is also provided in annex B for the combined water and metal correction factor that is applied when determining the capacity of the tank at reference temperature.
To find similar documents by classification:
75.180.30 (Volumetric equipment and measurements)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 8222
Revision Level
EDITION 2
Status
Current
Publication Date
Nov. 22, 2002
Language(s)
English
Page Count
10
International Equivalent
ISO 8222:2002 IDT* EN ISO 8222:2002 IDT