SS-ISO-10397 Stationary source emissions - Determination of asbestos plant emissions - Method by fibre count measurement (ISO 10397:1993, IDT)


Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

This International Standard specifies a method, using a fibre count technique, for the assessment of fibre concentrations in flowing gas streams in ducts, chimneys or flues from industrial processes using asbestos. This method may be used to determine fibre concentrations from a wide range of processes where it is known that "regulated" fibres are present in emissions. No attempt is made to identify asbestos fibre types separately from other fibres. NOTES 1 If fibre identification is required, reference should be made to ISO 10312. 2 This method may be used to check that dust collection equipment. used to trap or prevent asbestos fibres escaping into the atmosphere, is working properly and effectively. 3 This International Standard may be used to measure fibre concentrations as described in European Community Council Directive No. 87/217/EEC on the prevention and reduction of environmental pollution by asbestos. The range of application of the method for concentrations of fibres in ducts is about 0,05 fibres/cm3 to 10 fibres/cm3 , although this range may vary according to the sampled volume which in turn will depend on duct velocities and the sampling apparatus used.

To find similar documents by classification:

13.040.40 (Stationary source emissions)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Want this as a site license?

Designation Name

SS-ISO 10397:2020

Revision Level




Publication Date

Sept. 8, 2020



Page Count


International Equivalent

ISO 10397:1993(IDT)