SS-ISO-10791-8 Test conditions for machining centres - Part 8: Evaluation of contouring performance in the three coordinate planes

SS-ISO-10791-8 - EDITION 1 - CURRENT


Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This part of ISO 10791 specifies a method of checking the contouring performance of machining centres (or numerically controlled milling machines, etc., where applicable) by conducting circular tests in the three coordinate planes (XY, YZ and XZ) and by evaluating the radial deviation, F, and circular deviation, G, in accordance with ISO 230-4. NOTE Measurements of circular movements can be carried out by different methods as described in 6.6 of ISO 230-1:1996. These methods consist of using a rotating one-dimensional probe and a test mandrel, a circular masterpiece and a two-dimensional probe, or a telescoping ball bar. Other test methods may be applied if the accuracy of the equipment is the same as (or better than) the accuracy of the methods described. Influences of typical machine deviations on circular paths are shown in annex B of ISO 230-4:1996. The purpose of the checks by circular tests described in this part of ISO 10791 is to verify the circular movement - only in one position per coordinate plane of the machine, - at only one feed rate, and - to repeat the test once in the opposite contouring direction.

To find similar documents by classification:

25.040.10 (Machining centres)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

ORDER

Price:

$86.55        


Want this as a site license?



Designation Name

SS-ISO 10791-8

Revision Level

EDITION 1

Status

Current

Publication Date

April 20, 2001

Language(s)

English

Page Count

9

International Equivalent

SS-ISO 10791-8:2001 IDT