SS-ISO-128-40 › Technical drawings - General principles of presentation - Part 40: Basic conventions for cuts and sections
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 128 specifies the general principles for presenting cuts and sections applicable to all kinds of technical drawings (mechanical, electrical, architectural, civil engineering, etc.) following the orthographic projection methods specified in ISO 5456-2. For areas on cuts and sections, representation is according to ISO 128-50. Attention has also been given in this part of ISO 128 to the requirements of reproduction, including microcopying in accordance with ISO 6428.
To find similar documents by classification:
01.100.01 (Technical drawings in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 128-40
Revision Level
EDITION 1
Status
Superseded
Publication Date
July 27, 2001
Language(s)
English
Page Count
8
International Equivalent
ISO 128-40:2001 IDT