SS-ISO-16630 › Historical Revision Information
Metallic materials - Sheet and strip - Hole expanding test (ISO 16630:2009, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard describes a method of determining the hole expansion ratio in metallic sheets and strips with a thickness range of 1,2 mm to 6,0 mm inclusive and a width of at least 90 mm. NOTE This test is normally applicable to sheet metal and is used to assess the suitability of the product for forming flanges.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 16630:2012
Revision Level
2012 EDITION
Status
Superseded
Publication Date
May 10, 2012
Language(s)
English
Page Count
20
International Equivalent
ISO 16630:2009(IDT)