SS-ISO-48-7 › Rubber, vulcanized or thermoplastic - Determination of hardness - Part 7: Apparent hardness of rubber-covered rollers by Shore-type durometer method (ISO 48-7:2018, IDT)
SS-ISO-48-7
-
2018 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies a method for the determination of the apparent hardness of vulcanized- or thermoplastic-rubber roller covers, expressed in Shore hardness, for measurement where only medium precision is required. The method and apparatus used are essentially those described in ISO 48-4, the measurements in this case being made on the curved surface of the conditioned rubber-covered roller rather than on a flat test piece. Shore type A and type D instruments are specified, the latter being used for measurements on rollers of high hardness. NOTE With some rollers, there can be significant variation in the thickness of the rubber over the surface of the roller, which could affect the measured apparent hardness.
To find similar documents by classification:
83.140.99 (Other rubber and plastics products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 48-7:2018
Revision Level
2018 EDITION
Status
Current
Publication Date
Sept. 18, 2018
Language(s)
English
Page Count
16
International Equivalent
ISO 48-7:2018(IDT)